Search results

I ordered my new pump from Mac Motors and it was a much better quality than the one Melton used. Old pump had a lot of travel before it was solid. I was reading on HPG and it said the spring shouldn’t show on the right pump. I did notice that spring showed on old pump but not on new. I don’t...

I used gasket maker to hold gasket to plate and gasket on the pump. I didn’t want it on the block and I figured I would be trashing the pump if I changed it again. I would only have to clean it off of one side of plate that comes off. Not a lot of room in there and I could only get one hand

I covered the end of rod with grease to hold it in while I took forever to get the plate and pump on. I had about 1/2” of rod sticking out of block and that was in far enough for me to get pump on. I also started the metal fuel line to help hold pump up

Remove the 2 10mm bolts take plate off and see if rod slides right in.

You need to take that plate off to get the rod back in. I just did mine and rod slide out and against the plate and that tells me the angle is wrong to get it in with plate on. Gasket needs replaced also.