Search results

Thank you, Sir!

No worries, hurries. this thing isn't going anywhere!

The arm that the rotopac cylinder is attached to that pushes on the arm that is fixed to the cross shaft when the clutch release lever is actuated back at the rear winch station. . This would be looking at the engine/trans from the passenger side, engine to the front. The levers look like...

I still have not found a frame stamped VIN. Looked drivers side between steering box and cab, nothing I can see. The front part of the frame does not have the undercoating stuff like the rest of the frame/undercarriage. IF someone were to want to find a VIN stamp, where would it be? It isn't...

Well, I was WAY off! 3276 is the # on the tags. I looked on the frame and could find nothing. SO, when we do the stenciling, we will most likely use this number on the hood. Craig also said that the number on the doors was also on the right rear, on the back panel of the wrecker body. I don't...

As far as I remember sitting here, the number on the DP and rebuild tag is 8723, 8732, 8372, something like that. I will check and snap a pic tomorrow and look on the frame a bit closer.

Well, the numbers on the insides of both doors start with 00, so, maybe those numbers are original reg nos? The number on both the data plate and rebuild tag are 4 digit, 8000's number, 8372, 8723, I don't know off the top of my head. This is a '53 IHC. I'll snap a pic tomorrow and look under...

This is about the project that is on going here, https://www.steelsoldiers.com/threads/the-next-project-an-asmh.216290/. The truck is a 1953, M62. This truck was, on it's last assignment, assigned to the CANG. That is where it was acquired from. Inside the cab, on the doors are CANG markings...