Search results

Starter bracket I have a starter off of a 1008 that I will be using temporarily on my 998. Once I got it mounted I tried to put the support bracket on and it will not fit auaauaaua I put the bolt in the engine block and the hole for the starter stud did not line up with the stud. I thought that...

OK That crossmember is headed to my scrap pile. The transfer if finally mounted to the transmission. Now to connect the drive shafts, then plumb and fill the transmission. After that I will check and recheck everything then comes the good part. Test run of the engine. I hope it runs well.

Thanks Nattieleather, definitely a project, but I love a challenge. I found the mechanical modulator for the transmission and hope to get it in this week. I found out today that some of the exhaust manifold/header bolts have gone AWOL. I thought about taking the windshield frame to a local...

Slow and Steady When I first picked this up there was lots to be done and lots of parts needed. The first thing that I noticed was that the right rear geared hub was off and the transmission was gone. Little did I know, That was just the start. Everything that had been taken off that had a wire...

What does this fit?? This crossmember was in my M998 when I got it home. The transmission was out so I figured that was where it went. Wrong. I don't see anywhere it goes. Any Ideas?

I will get to the shop and get some pics this weekend.

I guess I went brain dead.aua I knew to go to the classifieds, but when you get a few years on you it is hard to remember everything. I will have to pay more attention to what I post. Maybe I wont get shot this time.

Thanks to everyone for all of the help so far. I have a wish list of parts for my1989 M998 that will help me get in pretty good shape on the mechanical side of this rebuild (I hope). I still have to go through all 4 geared hubs just to make sure all is well in there. Send me a PM with any parts...