-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Search results
-
M816 rear winch roller drain??
M816 rear winch "Roller ponding" - Fix Had forgotten to post these from some time ago. My solution was to extend the grease fitting then caulk the void: I/Fittings. II/Fittings installed in roller. III/Roller test fit in frame. IV/Cap in place. V/Masked nipple for painting (Nipple will be...- zebedee
- Post #10
- Forum: 5-ton Mods and Hot Rodding
-
M816 rear winch roller drain??
Pipe thread cap: Seems like a good fix. Any chance of pic yet Jeff?- zebedee
- Post #7
- Forum: 5-ton Mods and Hot Rodding
-
M816 rear winch roller drain??
Plan 'A'?? Ok, I HAVEN'T BEEN TO THE TRUCK YET!, but this is an initial thought after looking at the TM over breakfast. ... after this weekend is over, I'll pull stuff apart to see if this is a go. AARRON - mine are all siezed too, so I imagine there will be some pressing involved. If...- zebedee
- Post #5
- Forum: 5-ton Mods and Hot Rodding
-
M816 rear winch roller drain??
Has anyone made any mods to the side roller top bolt plate to allow or stop collection of water? I think a plastic cap would work but a little flimsy for the location with all the 'action' and heavy traffic that area receives... Possible a groove in the underside of the square bolt plate???- zebedee
- Thread
- Replies: 9
- Forum: 5-ton Mods and Hot Rodding