Search results

Much appreciated Dave

Flame heater has already been deleted. The pop tester looks interesting. Will do some more reading on that. Maybe one of these days my engine compartment will look like yours nemesis

To be honest, they were all fairly snug and 140 ft/lbs plus. I'll just start gathering parts and throw a bottle of sealant in it.

Update, did a retorque and fired it back up. Small air bubbles forming while running even at low rpm at front passenger corner of the head. Looks like gaskets in my future....

Thanks!

Thanks Will. Already checked that, went over all clamps. The wet residual on the water pump housing is from before I changed the thermostat. It's definitely coming from between the block and head. Dried it and wiped it down before the test drive, freshly wet afterwards.

No, it's the f250 in my avatar. And the 8k was just parts. I did all the labor. Sitting around 450hp and 1100 ft/lbs to on the hot tune. Its always in tow tune though. Always dragging a toyhauler or a gooseneck.

For sure. I'll be checking valves and everything else. I'm horrible at fixing "just one thing" I want my stuff done right. Last time I dug into my 7.3 it cost me 8k. Lol. New turbo, new injectors, 4 line fuel feed, fuel bowl reseal, billet intake plenum. New gaskets, sensors, seals. But its a...

It was definitely weeping out of the thermostat housing, I had just overlooked the possibility that it was leaking out of the head due to the nature and location of the leak.

After chatting with a few people, going to attempt a hot torque before going further as I just don't want to spend the money on parts right this second, as I had just changed the oil and all filters. If I can get by for a little while with a retorque until I can gather the parts (better studs...

So I've been fighting a couple small coolant leaks here and there. First was a freeze plug, then one of the head transfer manifolds was leaking from a gasket and an old hose along with the thermostat housing weeping. Got to take it for a spin tonight to get it up to temp and get home to inspect...