Search results

Thanks Tom, I didn't explain that I did take off the top and clean them up. They looked **** near brand new, so that wasn't where it was sticking. Ok, I pulled one of the injection pumps out, and moved the fuel stop lever by hand. then I pushed against the lever while it was opening the fuel...

Hey Tom and team, So, it's been cold out, and the generator has sat still for a bit. I'm back working on it. More to the story. It started right up after a week or two of sitting. then when we shut it down after a few hours of use, it won't start again. Exhaust temps about the same. Same...

Update to the thread. So, I've found some very interesting things. I'm about to take apart the injector pumps on the generator after finding that sometimes just sitting makes them stop pumping fuel. loosening the retaining bolt and turning it over usually get's it running in seconds, but...

Update and more questions... So I cracked the Pump lines and when I took off one, fuel starts flowing engine starts dragging. Plug it back in? All is back to running poorly, but running. Crack the second line, fuel barely dribbles. Ideas?

Thanks for the advice. I ran it about an hour, and only noticed poor performance under load, say 3000 watts. Startup is way more difficult than it was, before I could turn the switch, wait 1 second and release. Ran like a happy kitten. Now I have to hold it 10 seconds or so, and it runs...

Hello everyone, been off the board for a while. Now I'm enjoying my a3 with one less axle and a dump bed! Yay. But that's not why I'm posting. I have a MEP 802a that had very low hours. I lent it to my neighbor for their emergency and they ran 180 hours on it. Then, they forgot to put...