Search results

I'm at the point of frustration now with this thing. Changed the speed control box and no change. Anyone have an idea of where to go from here?

Heres what I found for the speed box. So in the troubleshooting on steps 12 of that document, I'm getting way over 2vdc while cranking for step 4 and I'm only getting 9.65 vdc for step 3 while cranking

i just ordered a new speed control box so hopefully that will fix my problem. Since I get voltage all the way to the box when it's on cold start but not when it's on normal, to me that says there isn't a short of some sort to the actuator. All the relays are good and the actuator works when it...

Do you or someone yiu know have one one of these sets on hand to test if there is voltage at pins a and b on the speed box when it's on normal?

si looking under the panel on the speed control unit, pins a and b are labeled actuator. When the selector switch is on normal, I don't get any voltage at those 2 pins. When it's on cold start, I get 22 volts. Would this be an indication that the speed control box is bad? I've rotated all relays...

Does this magnetic pickup conmection look right?

this thing is frustrating the heck out of me. If I can figure this thing out then I already have it sold.

I'm guessing that module is under the control panel? Any idea on what pins to check?

So I unplugged the magnetic pickup. When I cold start, the generator still ran and the magnetic pickup read 10.75 volts AC. Switched it to normal and it only cranks and shows 6.75 volts AC. I'm guessing the difference is the rpm but I didn't expect it to start either way. Any thoughts?

Does this picture look like the magnetic pickup has been messed with before?

should I take the magnetic pickup out and clean it? Does the TM specify how to test and adjust it correctly like it does with the mep generators?

Is there a relay or something that could be bad?

i did clean out the catch by taking out the screw on top and cleaning the screen and inside. I'm going to get a new oring deal for it in the morning just in case since it doesn't look brand new. If that doesn't do the trick, what else could it be? How do I get the governor actuator to show...

so I just replaced every fuel line with brand new ones. Still running on only cold start. When I unplug the governor control and it's on normal, I don't hear any action but when I do it on cold start, I can hear the governor control actuating inside the IP. Any experience with this?

if I leave it on normal, it will just crank and crank and never start. If I start it on cold start and then try to switch it to normal, it's like I hit the kill switch and kills the engine. If while it's running on cold start and I try to switch the selector to generator, same thing, it's like I...

The engine starts right up and runs good as long as the cold start is on. With that said, if it was a bad fuel pump, Would that make sense?

Still no luck with getting the GETT drash setup to run without being on cold start. Any other tricks you guys have experience with? Really need to get this thing fixed and moved

Superman, do you have a voltage regulator kit for a MEP-804A? I was told you're the man to contact for them.

does anyone have both manuals? Just bought one of these sets. Got the motor to run but will only run with the cold start switch on. Also, when I switch machine from off to generator, it shuts off. Shuts off if I turn the cold start off, even after the machine is up to operating temp. Any help or...