Search results

New sensor came in, and it's plastic..... Works though. tach jumped right to life after swapping the new sensor in.

@Ronmar called it. Pulled the sensor out and it was covered with metal.... mostly from the coil in the sensor that got chewed up by the ring gear. Glad I ordered that new one.

Well, still no tach movement. Likely the sensor needs adjusted or replaced. Ordered a new one just to eliminate one variable. When installing a new sensor, I need to thread it in until it bottoms out, then back it off a bit, but how far to back it off?

So, I went back out to give it another try. I took a small pick and ran around each pin 10 times or so, trying to get both the outside diameter of the hole and the area next to the pin. I also probed inside each of the pins with holes in them. I then blew it all out very thoroughly with the...

Well, this sucks... p/j 913 will not click together no matter what I try. It's keys, so it only goes one way, and it will close so much that you think it's done, but it's still about 1/16th of an inch from clicking together. I've sprayed it with Deoxit, and Fluid film, Blew it out with...

Yes, the hazards and heater panel lights both work. As does the PTO switch and the signal returning from the sensor (at least the PTO light comes on). I was really hoping to not need to pull that thing back out. Thanks @Ronmar

So, I've been on a journey to get my winch and a/C installed. Made a big move yesterday and got the options panel and the interior A/C unit installed. Not too much in the way of difficulties, but my options panel is not working. (All is well with the A/C unit) The options panel has two sets of...