-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Search results
-
K
M936A1 Hydraulic crane pressure
So the logic here is that with the power divider in you could overload the transmission at low RPM without it kicking down? A load is just a load whether it be driving the truck or the crane. In driving the truck up a hill as it stalls the transmission should kick into a lower gear; if it...- KN6KXR
- Post #6
- Forum: M939 series 5 ton trucks
-
K
M936A1 Hydraulic crane pressure
You have an auto throttle then. From reading a lot of posts I gather the A1 or A0 was equipped with these. I have an A2 and it has no auto throttle. I have to engage the power divider then use the hand throttle to crank it up to proper RPM. Yes I mean the 1-5 drive position. On mine without the...- KN6KXR
- Post #4
- Forum: M939 series 5 ton trucks
-
K
M936A1 Hydraulic crane pressure
Valve block will show zero when spools are at inactivated position. Pressure is only read from that port when valves are actuated. In order to set relief you have to max it out. I do this by raising the boom until it's at max travel. Then the pressure hits the relief and I set it there. Piece of...- KN6KXR
- Post #2
- Forum: M939 series 5 ton trucks