Search results

I actually decided to use cargo van seats in my truck. The van is flat through out, so there was no worry for risers or any of that, just welded on some angle iron and bolted them down! Trucks looking GREAT! Are you brushing the paint on or spraying it? What kind of prep are you doing before paint?

The funny thing is, I was going to use the EXACT same seats for the front and my seat is ripped in the EXACT same spot! Haha. But I got rid of those and went a different rout that was a little slimmer.

That thing is coming along real nice! Wish I could say the same about mine..haha

Are you just going to bend the metal as you go (from side to side) to form the curves at each end?

Looking good! Is the hardtop actually 18 gauge? Or is that just what your using? I've been debating on 16 or 18 for the top.

Yea I went through that thread post by post and a few others before deciding. I've actually talked to him on the phone and the other reason for doing that is so the bed would fit closer to the cab leaving a smaller gap, not being as long, and bringing the front axle a little closer to cut down...

Looking good! I just bought a 4x8 sheet of 1/8 metal for all my floor patches (had some rusty sections I had to repair as well) and it ran about $123. The only thing I'm now trying to figure out is how Im going to do my rear cab mount. I left the vent in mine and it actually put the mount on the...

I'm about to make the point of no return on mine here soon too! Slowly getting there.. You're doing a great job so far, keep the pics coming!

Subscribed! Always nice to see how others tackle a project.