Search results

Nice, if that was on my truck I would need a ladder to get up there to get the ladder...

Good idea r thanks, will give it a try after I get the second 923 from Ft. Hood this week.

Trying to get this box door un-seized, have been spraying pb blaster and beating on it for a week so far. I think I will take the box off so I can get a good swing with a hammer and punch on the ends of the hinge pin and maybe that will work. Otherwise will end up cutting the hinge off.

In process of removing the fuel hard line that goes halfway to the filter and the second half which is a flex hose so I can run a new one piece hose all the way from the tank to the filter. The old setup has the transition from hard to rubber hose where you cant get to it.

Removed the big canister fuel filter and found no filter in it, just a bunch of sand. Also found the hose from the filter to the engine all kinked up and cracked.

I will do a thread in the 5 ton Mods section after the parts get here and I get started. I have done some measuring and drawings and ordered two telescoping cylinders that are 3 stages. Im doing it different than what is usually done. Cylinders will be angled at approx. 45 degree angle...

I ordered the two hydraulic cylinders for the dump bed conversion. Then I greased the truck, checked axles and etc.

NICE ! That should do the trick.

I would certainly put a new filter in there. I will check mine to see if its there since our trucks seem to be from the same unit