Search results

I used 5.5 and got 1853,

The guy next door has never mentioned anything, tht's his way of fishing, that I didn't have . saw PLC thread and while looking around surprized atwhat i do have , Offered somebody in WTB section a tent wall for $1 for the command post 11 x 11

bottom is a stand alone temperature controller, will operate a heater to set point and takes several kinds of thermocouplers top right is your AC drive , and the top left is a 4 to 20 milliamp loop controller, I just have too much stuff

When I saw it I knew that was it, the rim is 1.5 inches smaller than the main body of 8 inches, so is it using the diference to push the oil out, because it's a function of RPM and Diameter with the average thickness of fluid in there to. for a low mod rotor a CO2 tank or Fire Extinguisher ...

Centramatic wheel balancers install behind the wheel. Once installed, centrifugal force causes the shot and oil filled aluminum balancing ring to automatically balance the tire and wheel as you drive down the road. Wheel Balancer FunctionThe free moving hardened lead alloy shot is bathed in a...

Component Specifications •Standard 3450 RPM Motor: •1/3 Horse Power •250 Watts •60 Hz •120/230 Volts •1200 G's •Custom 6000 RPM Motor: •1/3 Horse Power •250 Watts •50-60 Hz •120/230 Volts •Up To 3600 G's •Centrifuge Bowl: •22 oz Capacity •8" Diameter x 2" Deep •5.5" Opening at top •3 Drain...

Thanks, after looking around some I see more of what is being done and marketed, that was my line of thinking that fluid should come in closer to center .

Redirecting the flow is not going to help in this application, . would like to see ideas on your inside to trap dirt and the exiting of cleaned oil, maybe in another thread If you don't mind some questions

The Commonwealth of Virginia encourages recycling through technical assistance, recycling tax credits, and educational and program grants,

Just a thought, the turbine and impeller spinning at close to same speed give a high circular flow , just thinking it may tame the incoming fluid . guessing about 10 pounds oil and the converter spinning , it's some good fab work and he is having fun it seems with tuning the process. I like...

Might need to keep some of the parts in the converter, to control fluid flow , along page 12 has some info some of the shake may be in the fluid entering off center, just 8)

similar questions and also are you heating the oil before feeding into