Search results

Yes I had bare printed circuit boards built a while back, built up a few units sent unit out for beta test. Once beta testing was completed I had to re-spin the bare PCB design and received the new versions yesterday. Started populating the first one with components last night. Waiting on...

I received the one I ordered that's good for 150 PSI. Tested it with shop air from 20-135 PSI. It's a powered type and has very linear voltage output. A perfect candidate for my application.

No biggie. Shame on me, I should have done the mechanical gauge check before clicking "Buy It Now". I can always use them as spares or for repairing other sets in the future.

I just put a mechanical gauge on one of my 831's. Unfortunately the 802/803 sender won't work. aua Oil Pressure at startup is ~125 PSI and Oil Pressure when warmed up is 80 PSI. Looks like I have 2 spares senders coming for my 802.. Have a 150PSI sender on it's way to try this weekend.

Ordered a couple off of fleabay today.

I tried to PM you but your InBox is full. Might want to delete some old messages so you can receive PM's. Might you have the part numbers for the large oil pressure Senders?

I found the thread. It was about the Low Oil Pressure SWITCH. I'm looking to add a Oil Pressure SENDER to read the actual oil pressure.

Yes 8-) Working on a unit that combines the Governor Controller with the Remote Start and adding Oil Pressure and Engine Temp. sensors.

Looking for suggestions for a oil pressure sender (not a switch) for a MEP-831A. 1/8 NPT, reasonably priced, with either a nut/bolt terminal or spade connection. Resistance of sender not critical.