Search results

Yes it is. Here is the TM adjustment Procedure... ADJUSTMENT 1. Release control panel by turning two fasteners and lower control panel slowly. 2. Disconnect wire 147C from terminal 16 and wire 148C from terminal 17 of governor control unit (WP 0043, Figure 1, Item 56). 3. Set multimeter for...

Did you adjust the depth of the MPU per the -24 TM and verify it was putting out 2-3 volts AC?

Bingo

Magnetic Pickup Unit. It's a sensor screwed into the bellhousing and senses the lobes of the flywheel whizzing by and generates an AC voltage with varying frequency. The frequency it send out is used by the A5 to know what the engine RPM is.

Just a hunch but you may want to check the MPU. If it's not working the A5 won't know what the engine RPM is.

Yes

Do you have power at the outlet? If so then the issue is the contactor isn't closing when you lift and release the contactor switch. When running press the contactor lamp to test the light and see if it illuminates. If it does lift and hold the up switch and see if the lamp illuminates. If you...

Here is what the Libby T1 looks like

Here are the part numbers for the Libby based voltage regulator setup Libby Volt Regulator 6110-01-363-0493 P/N: 122-3054 Libby Volt Adjust Rheostat 5905-00-556-3350 P/N: 10K Ohms Libby R16 Resister 5905-00-106-9354 P/N: 3K Ohms Libby Power Transformer 5950-01-370-3328...

That's the correct resistor for use with Libby Regulator

T1 as I recall is the transformer you need to check to be sure it's the Libby version

R16 is on the back of the 50/60 Hz switch

The transformer in the second picture is not the transformer you need to check. In the picture is the current transformer. That one stays the same regardless if Libby or TRC. Dud the set come with a bad Libby regulator in it or was it missing?