Search results

I would love to have one of those as well. Will need to watch the auctions!

I started with the two-battery setup, so plan to keep that. I live in the South, so it rarely gets below 32 degrees here for very long. So far, the dual batteries are fine.

I must have been lucky, as all I had to do was remove the screw and the caps slid right off with no effort. I got lucky on my truck because it was listed as a "non-runner" and it had a flat on one of the tires, and one of the side rear windows was broken out, so the bidding was low on it. I took...

Just pump it up for a bit, then turn all four manifold valves in every direction a few times, then I removed the refill cap on the pump. Careful though, open it slowly, as the pressure may cause the fluid to come blowing out. I had to do that 3 or 4 times before mine started moving things...

As an afterthought here, you could probably email someone at Parker and find out the correct sizes of the backup rings as well if you needed those. Their purpose is to keep the high pressures from distorting the o-rings into a position where they might fail, so the backup rings don't really wear...

Last weekend, I used the $5 O-rings we cross referenced and I rebuilt my manifold valves. That got the hand pump to easily raise and lower the cab and spare tire. This weekend I used one of the rebuild kits on the Hydraulic pump and rebuilt that as well. As with most everyone that has done...

Thanks for posting this. I was able to find the PDF with these same numbers by digging a bit more, and I already placed an order from Allegheny York. A total of $65.00 including the backup rings. I guessed at those a bit, and they were the most expensive part. Without the backup rings, it was...

I need the O-rings and backup rings for the knobs on the manifold. There is a kit SK10-4, but it does not give the size of the o-rings. It only gives you a kit number that is $100 per valve, and I need to rebuild all 4, so I was hoping someone might know the sizes of them. A previous post...

Does anyone know the size of the O-rings and the backup rings, as I want to rebuild all 4 of my valves? The kit is like $98.00 for one valve, so $400 to rebuild all 4. I just can't see paying that for some o-rings. There has to be a way to figure out the sizes and order them directly as farming...