1951M1078
Well-known member
- 1,018
- 185
- 63
- Location
- Glendale,AZ
Removing the bed on my LMTV. Any tricks or things I need to know ?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Any tricks to pulling the bed ?
- Thread starter 1951M1078
- Start date
- 6,845
- 661
- 113
- Location
- Stratford/Connecticut
Stupid huck bolts. Have to grind or cut them off unless you have a ridiculously expensive special tool to remove them.
- 1,170
- 22
- 38
- Location
- Nashville, TN
Post #47 in this thread starts a M-1078 build... They used an abrasive cut off disc. This is really good reading when you get time. It will give you lots of good ideas.
https://www.steelsoldiers.com/showthread.php?152020-M1078-M1079-for-overland-camper/page5
https://www.steelsoldiers.com/showthread.php?152020-M1078-M1079-for-overland-camper/page5
1951M1078
Well-known member
- 1,018
- 185
- 63
- Location
- Glendale,AZ
If that is all I'm very lucky. Their all bolts ! Looks like the bed has been off before ?
- 182
- 23
- 18
- Location
- Portland, OR
I agree with previous posters. A cutting disk or torch is your friend. When I got my parts truck the military had started removing the bed and a lot of the bolts were already torched off. I continued the trend and torched the rest off. It was quick and easy. The 5-tons are a bit trickier with the subframe and trans cooler, but even they aren't too bad.