Rfwoodvt
New member
- 1
- 0
- 0
- Location
- West Coast of New England
Greetings All!
Long and short is I have an MEP 025A That I'm using to keep a forklift battery charged while off grid. I have a cable all prepped for the forklift battery end of things and and just inserted the stripped end of the cable into the genset terminals. Unfortunatley the first time I did that I shorted things out and cooked the stator along with the VR. I have since paid better mind of how the wire is inserted in to the terminals.
However, I'm sure there must be some appropriate terminal to put on the wire that then attaches to the load terminal on the genset but I cannot find it anywhere. Any chance someone here can post a pic of what that would look like or where i could find some?
If there aren't specific wire-end terminals is there a proper way to prepare the wire ends for use on the genset load terminals?
Thank for any and all input!
Rick
Long and short is I have an MEP 025A That I'm using to keep a forklift battery charged while off grid. I have a cable all prepped for the forklift battery end of things and and just inserted the stripped end of the cable into the genset terminals. Unfortunatley the first time I did that I shorted things out and cooked the stator along with the VR. I have since paid better mind of how the wire is inserted in to the terminals.
However, I'm sure there must be some appropriate terminal to put on the wire that then attaches to the load terminal on the genset but I cannot find it anywhere. Any chance someone here can post a pic of what that would look like or where i could find some?
If there aren't specific wire-end terminals is there a proper way to prepare the wire ends for use on the genset load terminals?
Thank for any and all input!
Rick