QuietProfessional
New member
- 2
- 1
- 3
- Location
- Arizona
I’m starting to get into an m1008 I bought. Only the gen 1 light would turn on and then dim once it was running. The batteries weren’t being charged by the alternators and if I turned the lights on the batteries would be drained quickly. I replaced all bulbs on exterior and interior. Gen 2 had no bulb or receptacle. I followed instructions from a previous thread and did 168 bulb for gen 1 and 194 bulb for gen 2. Gen 2 still doesn’t come on at all. When all the bulbs were replaced, I turned on the lights, everything turned on but then the headlights went out after a couple seconds and won’t turn back on. I’ll clean the contacts and check the gen 1&2 bulb’s board for continuity once I have time to get back to it. I’m hoping it’s something simple like that and not a short I have to dig for. Another thing worth noting is the truck will start without the service lights switch in the run position. Does anyone have any experience with something like this that can offer a best guess?