firecontrol86
New member
- 183
- 2
- 0
- Location
- San Diego, CA
Just wondering if anyone else had this issue or can tell me if I'm right. My heater died the other day(of course after the first snow) so after some research on here i checked the switch. Sure enough it was fried, the same pin I saw on someone else's post about it. Replaced the switch and worked fine yesterday. Today when I was warming up the truck and turned the heater on, the Gen 1 light was dimly lit while the heater ran. When I came back out the heater was dead again. Is my motor drawing so much current that it's frying the switch? Somebody chime in, I'm tired of being cold.