Injured Working On Blazer

[JDToumanian]

Hi Group,

A few weeks ago while I was working on my M1009 Blazer, I managed to break my arm (fractured ulna).....

I was kneeling on the brush guard with my right hand on the air cleaner while I looked carefully for fuel leaks after replacing my IP. I went to get down onto an upside down 5-gallon bucket that I had been standing on while doing the work. The bucket slipped out from under my feet and while trying to grab onto something my left hand went between the headlight and the brush guard while I continued to fall on my butt. SNAP!

The pic demonstrates how it happened. Needless to say, a proper step stool is on my shopping list... Be careful out there!

Regards,
Jon

 

[ABN173]

I remember a thread about a guy that fabricated some type of step that mounted where the front towing shackles are.

Thanks for sharing and hope you have a speedy recovery

 

[Takai13]

Ouch. It is always the simple things that get us. Proper footing is so important. I can't remember how many times I have done something similar.

 

[uscgmatt]

Ouch is right. That really hurts just imagining it. Good luck with your recovery.

 

[Sirblissfull]

Goldneagle has a 2 step fab piece on the front of the 5 ton I bought from him. I have not taken delivery yet but maybe he would post a pic if someone asked him.

 

[beaubeau]

At the age of 62, I always think twice before Closing the hood on my M818. It is Long and it is Tricky stepping down from that trk!!! I need something Smaller.

 

[bratpackdad]

Dang! That's painful! Don't feel bad, we all do stupid things. I replaced a light switch while the power was on (ZAP.) It happens to us all.

 

[91W350]

Funny you should post this today. I was standing on a 5 gallon bucket, only the lid, adjusting the belts on my M1009 and was telling myself how stupid that was. My bucket had about three gallons of solvent in it, not nearly enough ballast for my over-sized carcass. I hope yours was a clean break and that it heals with no further issues. Glen

 

[doghead]

Thanks for the eye opener/safety reminder.

I once fell through a plastic lawn chair, while getting down from a deuce. I was too lazy that time to get the step ladder that I usually use. I could have been cut bad, I was lucky.

Hope you heal fast and well.

 

[wreckerman893]

We are all guilty of bad judgement (and have the scars to prove it) at one time or another.

I have found that with my creaky old bones and bad knees a good step stool is now part of the tool requirements for working on deuces and other big items.

Thanks for sharing...we all feel your pain.

 

[319]

Good warning. Standing on a bucket is almost as safe as standing on the top of a step ladder.
I use one of these. I keep it in my Contact Maintenance Truck. Very handy.

 

[Recovry4x4]

Good warning. Standing on a bucket is almost as safe as standing on the top of a step ladder.
I use one of these. I keep it in my Contact Maintenance Truck. Very handy.

Ferro was working from one of those at the rally and I was thinking I need one. I really should buy or fabricate a tire step too. Thanks Jon, I hope I learn from your pain!

 

[salt6]

If you're wearing rings you might want to take them off too.

 

[RAYZER]

some non skid tape on the topside of the front bumper could reduce slipage when standing on it

 

[Lifer]

Ouch. It is always the simple things that get us. Proper footing is so important. I can't remember how many times I have done something similar.

You got a lift kit under that CUCV, or are you just short? I can change the plugs on a gasser deuce with my feet flat on the ground, so it's hard for me to understand why you'd be standing on a bucket.

 

[swbradley1]

I hope you have a speedy recovery. People can make fun of me but Gimp has seen my setup. I use a stepladder to climb up onto my rolling scaffolding from Menards. I have two that I can put next to the trucks so I have a nice safe work platform.

sw

 

[clinto]

Geez Jon, that picture makes me feel like I can hear the SNAP sound in my head!

That must have hurt like he....... a lot.

Do the Doctor's say there will be any long term issues stemming from this?

Thanks for reminding everyone how easy it is to get hurt and to be careful.

 

[USAFSS-ColdWarrior]

OUCH !​

I've always been told that it's best to learn from the experiences of others....

... Sorry the THIS experience had to be YOURS.​

GET WELL SOON !​

 

[waayfast]

Years ago my wife(then) was standing up in the extreme left side of the floorboard of our Chevy van while trying to lean out to scrape the frost off the windshield.Her feet slipped off the edge and her head (neck)went between the door and the windshield post!!Luckily when her feet hit the ground they didn't slip out from under her and being almost six foot tall saved her from literally hanging herself.Scared the absolute crap out off both of us!

Sorry for your misfortune but thanks for the reminder to be careful.

Jim

 

[WARWAG]

A fluke accident but a very good eye opener for the rest of us. Thanks for posting. I hope your arm heals up fast. Thanks again for the saftey tip. Step stool will be picked up today.