braddrummond
New member
- 22
- 0
- 0
- Location
- Yorktown, VA
Trying to find a barring tool for the nhc250. Looks to be the same as the 5.9cummins tool ? Can anyone confirm before I buy one to try????
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
NHC250 Barring tool part #????
- Thread starter braddrummond
- Start date
TurboMustang370
Member
- 524
- 1
- 18
- Location
- Hamilton, NJ 08690
I have the tool for a Cummins 8.3 6cta engine, "should" be the same. I can mail it to ya as long as you promise to mail it back when done in the same condition. PM me.
braddrummond
New member
- 22
- 0
- 0
- Location
- Yorktown, VA
Thanks, Does it have a part # on it? I've found a few online just wanted to confirm before buying. I have a Dodge diesel also, so I was just planning to buy one if its the same.
Brad
Brad
TurboMustang370
Member
- 524
- 1
- 18
- Location
- Hamilton, NJ 08690
I'll look at for a part number when I get home. I tried finding the online store I purchased it from again and cannot locate the site.
- 2,811
- 41
- 38
- Location
- Mt. Eden, KY
Can you post a picture of the barring tool?
TurboMustang370
Member
- 524
- 1
- 18
- Location
- Hamilton, NJ 08690
This is the one I used for the 8.3 6CTA in the M932a2
- 2,811
- 41
- 38
- Location
- Mt. Eden, KY
Thank you, a picture is worth a thousand words, (or the applicable section of the TM). It would be a little tricky to fab one up.
JC
JC