• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

P912A connector

JIM IN AZ

New member
5
10
3
Location
ARIZONA
Hi, does anyone know what the P912A connector is for? I bought a new PDP/wire harness from G/P last year and installed it when I swapped cabs on my M1079. It is a Gen0 PDP, the old harness I took off does not have this. It is a single dark gray wire coming out of the harness under the PDP at the first branch off, it goes into a 15-pin connector. I cannot find any reference for it in schematics or -24p. P912, is for CTIS/heater in the center cab position. If pictures are needed, I can try tomorrow. Thanks.
 

JIM IN AZ

New member
5
10
3
Location
ARIZONA
I did not see any, I will look again tomorrow. Only 4-5 inches of wire came out of the wire bundle, and it was bare. Almost like an afterthought, all other wires are white, numbered and most are covered well.
 
Top