BuiltMFG
Member
- 148
- 5
- 18
- Location
- Denver, CO
So I've torn my dash out to send to powdercoat and that means the diagram on the bottom of the panel cover is getting roasted off. I have rebuilt it in Illustrator to have it engraved on the underside. I'm only missing a couple pieces due to a blurry image.
On the far left it says 24 VOLT IGN and then there is a circle under it that I can't make out. Can anybody help me out?
Anyhow, once I finish this I will post the PDF if anybody needs it (I could use another set of eyes on it to verify everything). It doesn't exist in the TM as far as I know.
This is out of a 1078A1 just FYI
Sent from my iPhone using Tapatalk
On the far left it says 24 VOLT IGN and then there is a circle under it that I can't make out. Can anybody help me out?
![](http://uploads.tapatalk-cdn.com/20171130/b2ecb6b63d08ec31e3b2e81bfe98ab1c.jpg)
Anyhow, once I finish this I will post the PDF if anybody needs it (I could use another set of eyes on it to verify everything). It doesn't exist in the TM as far as I know.
This is out of a 1078A1 just FYI
Sent from my iPhone using Tapatalk