switch harness for high beams

[firefox]

I can't seem to find the part in the TMs for the switch
that controls the high beams. I know that it's
operation is described in section 2-16 of the -10,
and that it starts at the end of the turn signal lever and
winds down the inside of the
column and then plugs into some other harness.

What I need is the page in one of the 20-P or 34-P TM
that has the picture of the part along with the
references to the part number.

Hopefully some one can point me to the right
page so I can order the part.

Any help is very much appreciated on fixing this problem.
Also any references in the TMs discussing the
replacement procedure.

Thanks,
Bruce

 

[dependable]

The switch is under the dash on the left of steering column. It is run by a rod on the directional signal lever. Remove plate held on w 4 screws just under steering column and it is there. Same as civilian trucks of era.

 

[firefox]

Wow, thanks a bunch.
Bruce

 

[gungearz]

I think other then the TM's, do you have just the basic chiltons manual for it...? You would be surprised to see most of it is the same.