- 39
- 54
- 18
- Location
- Wisconsin
I have a Vr board from a oo3 I believe that I have no idea if it is good. Would it hurt anything to install it in a working 002 to see if it is any good? I know very little about the electrical side of things.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Testing ac VR mep002/003
- Thread starter Dog Breath
- Start date
Triple Jim
Well-known member
- 1,379
- 304
- 83
- Location
- North Carolina
That's a legitimate way to test it. The same regulators were used in both generators.
- 2,207
- 3,772
- 113
- Location
- Pepperell, Massachusetts
You could certainly try it.
If needed, I have a test setup that can test them per the TM. If it fails I can troubleshoot and most likely repair it.
Just finished up troubleshooting and repairing 7 of them last week.
Failures I encountered were bad Q3 transistors, some bad Q1 and Q2 transistors, bad diodes and some burned up resistors due to transistor faiures. One had a damaged potentiometer due to a stupid OEM assembly error.
If needed, I have a test setup that can test them per the TM. If it fails I can troubleshoot and most likely repair it.
Just finished up troubleshooting and repairing 7 of them last week.
Failures I encountered were bad Q3 transistors, some bad Q1 and Q2 transistors, bad diodes and some burned up resistors due to transistor faiures. One had a damaged potentiometer due to a stupid OEM assembly error.