Wema Fuel Sender For mep 803a

[Triton]

I am going to clean out my fuel tank because the tube with the screen filter is rusted. I want to replace the fuel sender with the Wema style sender, I thought I saw a thread on the part number to do this but I can only find the info fro an 802. If anyone has done this do you have the part number or size and ohm rating needed to do this for my 803? Or maybe point me to the thread on this info
Thanks

 

[Ray70]

Here's some additional info

MEP-803A Pegs fuel gage all the way down past empty.

I just got done fixing one of my MEP-803A's that was randomly pegging the fuel gauge all the way to the left. It was pegged down when I bought it, so I swapped in a known good gage out of another 803' and it seemed fine. I load tested the machine for about an hour, then shut it down. Next time I...

www.steelsoldiers.com

The 803 uses the same sender just in an 8 1/2" instead of the 5 1/2" length.
But pay attention to the notes about the possibility of it rubbing on the lower rear wall inside the tank.
I've typically epoxied plastic rings to the base of the sender ( just big enough to fit through the opening in the tank ) to prevent the float from touching the side of the tank.