Crash_AF
Active member
- 1,530
- 7
- 38
- Location
- Colorado Springs, CO
Well, I shorted out my 1008's VM to one of the heater control screws while working in the dash and now it doesn't work.
I replaced the fried 28V fuse and the VM worked for a few minutes, then quit. I checked the plug with a multimeter and it had good voltage so I checked the terminals on the VM and it's dead. Replaced it with a spare and it works fine.
Does anyone know if there is any way to repair the VM or is it garbage?
Later,
Joe
I replaced the fried 28V fuse and the VM worked for a few minutes, then quit. I checked the plug with a multimeter and it had good voltage so I checked the terminals on the VM and it's dead. Replaced it with a spare and it works fine.
Does anyone know if there is any way to repair the VM or is it garbage?
Later,
Joe