ke5eua
Well-known member
- 2,568
- 41
- 48
- Location
- Baton Rouge (Central), LA
Not yet, it is hard to get to the valves under the water and muck.
That is actually the first thing that crossed my mind when it got stuck.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
So this just happened...
- Thread starter ke5eua
- Start date
That is actually the first thing that crossed my mind when it got stuck.
jdknech
Active member
- 1,095
- 6
- 38
- Location
- Jeffersonville, Indiana
I know it sucks getting in the water/mud/muck to get to the valve stems, but worth it if it saves you a tow bill.. its saved my butt a couple times..
ke5eua
Well-known member
- 2,568
- 41
- 48
- Location
- Baton Rouge (Central), LA
Yeah I know. I'm going to get some bigger rope tomorrow and while I'm battling getting the old rope off I'll try to get to the stems.
It's moments like this when I miss ctis
jdknech
Active member
- 1,095
- 6
- 38
- Location
- Jeffersonville, Indiana
except this is when the CTIS would fail on you.. lol If I was closer I would come pull it out for you.. good luck with it!
ke5eua
Well-known member
- 2,568
- 41
- 48
- Location
- Baton Rouge (Central), LA
The vid I tried the rope in the duals rapped around a tree to try and pull myself out.
I tried to pm Tim but his box is full.
wreckerman893
Possum Connoisseur
- 15,629
- 2,054
- 113
- Location
- Akenback acres near Gadsden, AL
Unless you get some really big rope you are pi$$ing in the wind. You need some steel cable with hooks on both ends. Hook one hook into the hole in the rim and use the other one to choke up on your anchor. You need to have the truck in Low Range to keep the wheels from spinning too fast. You should have a slow steady pull. Your problem is probably compounded by the suction created by the gooey mud. See if you can download the Vehicle Recovery and Evacuation TM. It shows a lot of field expedient ways to recover a vehicle.
ke5eua
Well-known member
- 2,568
- 41
- 48
- Location
- Baton Rouge (Central), LA
Low and reverse, isn't that a bad combo?
- 12,195
- 325
- 0
- Location
- gainesville, ga.
NO
After you get it out and you PULL all six drums and bearings to get the water out and repack the bearings you WILL learn why playing in the mud and water with a 5t is not the best idea on a nothing to do weekend.
Last edited:
212sparky
Well-known member
- 1,822
- 38
- 48
- Location
- Monroe/ Ohio
In the m939 class trucks on hard pavement yes on soft muck no. You are in the 809 series with a clutch to let out the binding the auto trany wont let go of.
ke5eua
Well-known member
- 2,568
- 41
- 48
- Location
- Baton Rouge (Central), LA
I'm guess your saying no.
I just don't want to grenade the transfer.
I would bring the tractor to lift but it just so happens the truck to pull the trailer is suck in some crappy stuff, lol
I'll get some cable tomorrow. I was just worried about adverse effects on the wheels.
- 9,604
- 1,493
- 113
- Location
- mid- michigan
You missed this part You should have a slow steady pull. As in not much over idle speed
ke5eua
Well-known member
- 2,568
- 41
- 48
- Location
- Baton Rouge (Central), LA
I'm great full for all the replies.
I have about 6 mins of video of me cursing and falling and cursing some more. I decided not to post that one.
I'm glad the wife listened to me when I told her to back the 4 wheeler into a little area surrounded by trees. I was afraid of the rope breaking and I've seen first hand the end results.
I have about 6 mins of video of me cursing and falling and cursing some more. I decided not to post that one.
I'm glad the wife listened to me when I told her to back the 4 wheeler into a little area surrounded by trees. I was afraid of the rope breaking and I've seen first hand the end results.
ke5eua
Well-known member
- 2,568
- 41
- 48
- Location
- Baton Rouge (Central), LA
I do need to refresh myself with the recovery tm.
I did h8 school back in 04 so it's been a while.
Plus you get a little lazy when you are stuck on a 88 or hemt wrecker.
Ahh, my 88, I miss her so much.
I did h8 school back in 04 so it's been a while.
Plus you get a little lazy when you are stuck on a 88 or hemt wrecker.
Ahh, my 88, I miss her so much.
DanDan
New member
- 64
- 2
- 0
- Location
- Cambridge, On. Canada
Best of luck to you! She'll come out!
ke5eua
Well-known member
- 2,568
- 41
- 48
- Location
- Baton Rouge (Central), LA
If not I'll sleep in her till she is ready to.
- 4,299
- 3,132
- 113
- Location
- Fort Worth, Texas
Why not use tow straps in place of rope/cable/chain to winch yourself out? "Horror-Freight" (Harbor Freight) has 10,000lb straps for cheap often and I can shoot you some 25% off coupons. Link them up and have at it.
If that doesn't work and you can't get someone to get in there then you may be SOL and have to wait for it to dry up some. I did the same thing with my M813 around Christmas rescuing three stranded 4x4s who got into it bad. At the end of the day I was the one stuck and it took a night of digging, improvised stick/wood ramps, and a tug from a CUCV to get out. Really all she needed was a little nudge.
http://www.steelsoldiers.com/showthread.php?116227-SS-Friends-are-the-BEST-there-are!&highlight=
If you need to get sooner than that you can put your nose to the grind stone and drain away the standing water, build those wood ramps, and then air down the NDTs to roll out in reverse.
If that doesn't work and you can't get someone to get in there then you may be SOL and have to wait for it to dry up some. I did the same thing with my M813 around Christmas rescuing three stranded 4x4s who got into it bad. At the end of the day I was the one stuck and it took a night of digging, improvised stick/wood ramps, and a tug from a CUCV to get out. Really all she needed was a little nudge.
http://www.steelsoldiers.com/showthread.php?116227-SS-Friends-are-the-BEST-there-are!&highlight=
If you need to get sooner than that you can put your nose to the grind stone and drain away the standing water, build those wood ramps, and then air down the NDTs to roll out in reverse.
If you can't get her out you shouldn't be afraid of someone else driving off in her.
ke5eua
Well-known member
- 2,568
- 41
- 48
- Location
- Baton Rouge (Central), LA
Thought about tow straps, problem is distance to a strong enough tree to anchor offWhy not use tow straps in place of rope/cable/chain to winch yourself out? "Horror-Freight" (Harbor Freight) has 10,000lb straps for cheap often and I can shoot you some 25% off coupons. Link them up and have at it.
If that doesn't work and you can't get someone to get in there then you may be SOL and have to wait for it to dry up some. I did the same thing with my M813 around Christmas rescuing three stranded 4x4s who got into it bad. At the end of the day I was the one stuck and it took a night of digging, improvised stick/wood ramps, and a tug from a CUCV to get out. Really all she needed was a little nudge.
http://www.steelsoldiers.com/showthread.php?116227-SS-Friends-are-the-BEST-there-are!&highlight=
If you need to get sooner than that you can put your nose to the grind stone and drain away the standing water, build those wood ramps, and then air down the NDTs to roll out in reverse.
If you can't get her out you shouldn't be afraid of someone else driving off in her.
I had to wrap around three trees because that area doesn't have really big ones.
Jeepsinker
Well-known member
- 5,399
- 456
- 83
- Location
- Dry Creek, Louisiana
I could come and get you out, but I have to wait for this kidney stone to pass first.
EmbarkChief
Member
- 86
- 2
- 8
- Location
- Houston, Texas
Yellow Nylon? You sure it wasn't polypropylene ? It's going to take some serious rope to break that suction. I would also recommend going much slower to reduce the shock load.