KaiserM109
New member
- 1,108
- 4
- 0
- Location
- SE Aurora, CO
I am considering bobbing my M923A1, so I crawled under it to see what I was going to have to unhook, remove, etc and I spotted the ABS sensor. I am afraid that I can’t just unhook it because the ABS controller will probably think the wheel is locked up and start pulsing the brakes.
I have seen several threads on bobbing a 5 ton, and I believe that all M939 series have probably been upgraded to ABS brakes because of the issue with killing the engine and losing power steering when the driver locks the brakes. Therefore someone out there in SS land must have addressed this problem already. I would like to hear what you think about it, what you know and what you think you know.
Arlyn
I have seen several threads on bobbing a 5 ton, and I believe that all M939 series have probably been upgraded to ABS brakes because of the issue with killing the engine and losing power steering when the driver locks the brakes. Therefore someone out there in SS land must have addressed this problem already. I would like to hear what you think about it, what you know and what you think you know.
Arlyn
Last edited by a moderator: