M1009 Drag Link Dust Boot

[Russm]

Having trouble finding this piece. Putting new axles under the m1009 and noticed the dust boot was torn up so I need a new one.

Cannot for the life of me find one after searching for several days
Here's hoping someone has a source

 

[cucvrus]

I am not sure what you are refferring to as a dust boot. Where is it attached? Are you talking the rubber that hangs from the inside / underside of the front inner fender aprons? Or are you talking the ones that go on the inner drive axle iself? I always get that dust seal on the axle at Autozone. The inner fender apron one you can make or buy used or new at LMC.

 

[m1010plowboy]

Steering grease pizza pocket dust boot

I have a bad one on the M1010 and I'm thinking this one or one like it is what you're referring to.



I bought used replacement parts but it would be nice to just replace rubber if it's possible.

 

[Smokinyoda]

I had same problem, couldn't find anyone willing to just sell me the dust boot. Came across this article searching the interweb and I figured it was worth a shot. Wouldn't try it on a new joint, but a new joint would come with a boot.

http://www.instructables.com/id/Poor-mans-tie-rod-end-or-ball-joint-boot/

 

[Russm]

Yes plowboy that's what I'm referring to.

 

[timarr]

Those grease boots are at pep boys in the speed shop section made by energy suspensions. 2 boots for 8 bucks part #
9.13119g

 

[Russm]

Thanks Timarr i will check thoseout

 

[Russm]

Those grease boots are at pep boys in the speed shop section made by energy suspensions. 2 boots for 8 bucks part #
9.13119g

Found the pair on amazon for $7.50 shipped. Fits like a glove

 

[Smokinyoda]

Found the pair on amazon for $7.50 shipped. Fits like a glove

Thanks for updating this. I saw those but after reading the review that they were to small and didn't fit I was hesitant to try. Ordering a set right now!