jimm1009
Well-known member
- 1,165
- 71
- 48
- Location
- Louisville, KY
I am 95% sure that I found a truck for me.
I am a former Deuce owner but sold my last M35A2C a few years back for stupid reasons .
I will need to drive it about 370 miles to get it home if the deal goes through.
I want to purchase locking hubs for the front and was thinking about
putting a front drive flange on the left forward axle to disengage and make it easier to drive.
Now as an alternate, I could leave that axle shaft in and just remove the 2nd rear driveshaft and the
both axle shafts and put the front drive flanges on the 2nd rear axle for the drive
home. Am not going to bob it but it make become a 4 x 4 over it's original configuration.
I am aware of the single lockout with double splined axle shaft mod. but can not do that
now in case it does loose an axle.
End desired result is to make it easier on fuel and a little better drive home since it will be all day.
Jim
jimm1009 here on s.s.
or
m1009jim@yahoo.com
I am a former Deuce owner but sold my last M35A2C a few years back for stupid reasons .
I will need to drive it about 370 miles to get it home if the deal goes through.
I want to purchase locking hubs for the front and was thinking about
putting a front drive flange on the left forward axle to disengage and make it easier to drive.
Now as an alternate, I could leave that axle shaft in and just remove the 2nd rear driveshaft and the
both axle shafts and put the front drive flanges on the 2nd rear axle for the drive
home. Am not going to bob it but it make become a 4 x 4 over it's original configuration.
I am aware of the single lockout with double splined axle shaft mod. but can not do that
now in case it does loose an axle.
End desired result is to make it easier on fuel and a little better drive home since it will be all day.
Jim
jimm1009 here on s.s.
or
m1009jim@yahoo.com