MTVR MK23 Transfer Case Info

[Ward0481]

I'm trying to source the transfer case output shaft seal going to the front end. Does anyone know what the transfer case is (make/model) and or where to source the seal?

Also looking for drivers side fender, the one that attaches to cab?

 

[DeMilitarized]

I'm trying to source the transfer case output shaft seal going to the front end. Does anyone know what the transfer case is (make/model) and or where to source the seal?

Also looking for drivers side fender, the one that attaches to cab?

It is an oshkosh 30000 transfer case. Seals are probably going to be expensive. This might be it not sure dont quote me on it. The brother to the 30000 is the 55000 used in the hemtt and m1070 HET. The fender is going to likely be impossible to find unless you find someone with a parts truck or pay oshkosh $2000 per fender. https://www.oshkoshequipment.com/products/detail/19/5457/Transfer-Case-Rear-Output-Shaft-Flange-Seal

 

[NDT]

The seal should have a number on it, a bearing house can usually source any seal. If it turns out to be some kind of proprietary part, they can come up with a seal if you provide the retainer ID and shaft OD and width of the seal.

 

[Ward0481]

It is an oshkosh 30000 transfer case. Seals are probably going to be expensive. This might be it not sure dont quote me on it. The brother to the 30000 is the 55000 used in the hemtt and m1070 HET. The fender is going to likely be impossible to find unless you find someone with a parts truck or pay oshkosh $2000 per fender. https://www.oshkoshequipment.com/products/detail/19/5457/Transfer-Case-Rear-Output-Shaft-Flange-Seal

I think i have been able to source parts for the transfer case.. Ill follow up and share the info if it works out.

 

[rockertype]

Also looking for drivers side fender, the one that attaches to cab?

The fenders are 660 bucks per side direct from Oshkosh.

 

[Bearded Guy]

I think i have been able to source parts for the transfer case.. Ill follow up and share the info if it works out.

Did your source for parts ever pan out? Thx