Sky track 6000m fork functions

[Kyle722]

Hello I have a sky track 6000m that I’m having issues troubleshooting. All functions for the fork in/out don’t work (functions for when the button is pressed down). Also one of the attachment functions are inop. I have read through other threads and I have had no luck with ts. Is there anyone that is familiar with those or anything they would check? Thanks

 

[Mullaney]

Hello I have a sky track 6000m that I’m having issues troubleshooting. All functions for the fork in/out don’t work (functions for when the button is pressed down). Also one of the attachment functions are inop. I have read through other threads and I have had no luck with ts. Is there anyone that is familiar with those or anything they would check? Thanks

.
Have you tried looking in the TM (Technical Manual) for the SkyTrack?

Forklift, Rough Terrain 6000# Variable Reach - aka: SkyTrack

. Here are the TM's for the Rough Terrain 6000 LB Forklift gathered in one place. Lubrication Order LO 10-3930-660-12 Operator's Manual TM 10-3930-660-10 Unit Maintenance Manual TM 10-3930-660-20 Unit Maintenance Repair Parts & Special Tools TM 10-3930-660-24P Direct and General Support...

steelsoldiers.com

SkyTrak Manual Supplement 31200693-10-10 (aka JLG)

. Stumbled across this book posted on-line. Model MMV (Tier 2) Serial MV1210 or higher For Use with: TM 10794B-24/2, TM 10794B-12/1, and TM 10794A/B-24P/3,

steelsoldiers.com

 

[Guyfang]

At the end of the boom, there is a junction box. Open it up and see if it has water in it and if the Circuit Card is damaged/burnt up. Also check the joy stick cables, wires and plugs. BUT first spend some time reading the TM, so you understand what is supposed to happen when when you initiate the varies functions.

 

[Kyle722]

At the end of the boom, there is a junction box. Open it up and see if it has water in it and if the Circuit Card is damaged/burnt up. Also check the joy stick cables, wires and plugs. BUT first spend some time reading the TM, so you understand what is supposed to happen when when you initiate the varies functions.

Is there a way to test the circuit card? I have 24v coming in but with the joystick button pushed in and stroked there is no output. I will read through the manual in the meantime. Thanks!

 

[Guyfang]

There is a thread in the forum where someone tested and repaired the card. Its been a long time ago. But I do remember it. Try looking a bit more in the forum.

 

[Mullaney]

Is there a way to test the circuit card? I have 24v coming in but with the joystick button pushed in and stroked there is no output. I will read through the manual in the meantime. Thanks!

.
You might also try cleaning those four wires at the bottom and at the top of the "card". That white crusty looking stuff will keep you from transmitting power correctly. Clean them - one at the time - then put some anti-oxidation paste on each contact. Do the same on those four at the top as well...

Let us know how it goes.

 

[Kyle722]

.
You might also try cleaning those four wires at the bottom and at the top of the "card". That white crusty looking stuff will keep you from transmitting power correctly. Clean them - one at the time - then put some anti-oxidation paste on each contact. Do the same on those four at the top as well...

Let us know how it goes.

Will do this. Thanks for the advice!