-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Transmission light is off.
- Thread starter M1151A1
- Start date
- 2,948
- 4,286
- 113
- Location
- Olympia/WA
Are you sure that the circuit breaker near the relay isn't tripped?
Does not have any play and has continuity
- 2,948
- 4,286
- 113
- Location
- Olympia/WA
Do you have voltage going into and out of the relays? Also voltage into and out of the breaker?
This thread should help, has wiring diagrams with wire numbers too. Has the wire numbers as well, it’s easy to follow:
HMMWV No Power to TCM, No Transmission Light
Hey Guys, I recently purchased a 1998 M1097. I knew the trans was in limp mode when I got it and the Trans Light will not illuminate. I replaced the trans light. I replaced the Transmission Relay. I checked the connections at the battery. I have power at the trans relay but when testing the...
www.steelsoldiers.com
- 6,832
- 9,481
- 113
- Location
- Papalote, TX
Likely one relay is for something else that may or may not still be installed, you should only have one transmission relay
- 4,386
- 4,158
- 113
- Location
- Brentwood, Calif
The relay is universa, it’s designed to switch on 12v when 24v is supplied in the case of the Trans relay, the other Relay is for windshield de-icer or AFES, can’t remember which one at the moment. We remove all that extra wiring as it’s no longer needed, the transmission TCM power runs through them on 29T Which is relay wire #2, if 29T is not plugged in or cut? You will be in limp mode
Hello guys. Sorry, I could not reply sooner (I was swamped during the week). I appreciate all the support from you a LOT. I do this project mostly during the weekend. Here is an update: I have 12V on pin Z, I have ground on pins a and b on J1 connector. On J2 connector: I have ground on A and F and 12V on D. Here is a picture: there are two 29 T in this compartment, one (29T) and another with (J12 29T P32A). Which one should be connected to wire 2 on the relay?
