• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

CARA has returned

Karl kostman

Well-known member
Steel Soldiers Supporter
2,305
889
113
Location
Fargo ND
The first thing I would do is go over all the seams with a good RV type sealant, everything on the roof sides and front of the unit then see what you have. These type of leaks can be difficult to pin point because the water gets in and then can very possible flow to somewhere else. I had a shelter in a Deuce that had a similar issue and just went over every seam on the unit then on the rook I went over every rivet and bolt in it and that was the end of it. If its not obvious where the leak is your best bet is to re-seal everything!
 

serpico760

Well-known member
Steel Soldiers Supporter
652
1,633
93
Location
San Diego, CA
The first thing I would do is go over all the seams with a good RV type sealant, everything on the roof sides and front of the unit then see what you have. These type of leaks can be difficult to pin point because the water gets in and then can very possible flow to somewhere else. I had a shelter in a Deuce that had a similar issue and just went over every seam on the unit then on the rook I went over every rivet and bolt in it and that was the end of it. If its not obvious where the leak is your best bet is to re-seal everything!
What I did on my expansible van habitat, was to sand down and clean the whole roof, wipe it with alcohol and acetone, and then coat it with Henry's tropi-cool Gray silicone roof sealant. Not a single drop of leakage after that and it keeps the roof a lot cooler. Use their silicone sealant on all the visible seams first and then coat the whole thing including over the edge like an inch or so
 

Bryteayes

Active member
Steel Soldiers Supporter
74
106
33
Location
San Angelo, TX
I used Liquid Rubber seam tape on all seams on the roof. I coated the roof with three layers of the Liquid rubber. Every screw, bolt on the roof was sealed.

I worry about the marker lights being a source of the leaks. The elephant in the room is of course the windows.
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks