- 4,210
- 37
- 0
- Location
- Las Cruces, NM
I've measured one motor (LDT-465) I have access to, the rear main flange where the rear main seal contacts the crankshaft. I came up with 4.998"/4.997" ish....
Does this sound right?
Was discussed here, but I thought I should stop jacking vtach's thread. . .
http://www.steelsoldiers.com/deuce/33093-rear-main-leaking-after-replacement.html
Does this sound right?
Was discussed here, but I thought I should stop jacking vtach's thread. . .
http://www.steelsoldiers.com/deuce/33093-rear-main-leaking-after-replacement.html
Last edited: