I am befuddled to say the least.
All wheel cylinders have been replaced.
All lines have been replaced, both hard and soft.
New master cylinder a couple of years ago.
New airpack a month ago.
BUT, I once again am having the same problem - if I drive at 50 m.p.h w/o stopping on the interstate for more than 45 minutes, when I do finally exit and apply the brakes, they drag and do not release.
Opening the bleed valve on the new airpack blew out fluid, and then I was good to go.
Drove home using surfaces road w/o problems.
What else can be going wrong?
All wheel cylinders have been replaced.
All lines have been replaced, both hard and soft.
New master cylinder a couple of years ago.
New airpack a month ago.
BUT, I once again am having the same problem - if I drive at 50 m.p.h w/o stopping on the interstate for more than 45 minutes, when I do finally exit and apply the brakes, they drag and do not release.
Opening the bleed valve on the new airpack blew out fluid, and then I was good to go.
Drove home using surfaces road w/o problems.
What else can be going wrong?