pinwormfood
New member
- 64
- 0
- 0
- Location
- easton, pa
hey guys, a couple of quick questions that I have searched for and came up with nothing:
1. I would like to make the rear power bar that is behind the pass seat on the wall 12 volt so i can run a few electronic devices from it. what is the easiest way. right now, it is disconnected from the 24 volt one bolted to the firewall.
2. i just blew out the drivers muffler last night....sounds awful. i was thinking about running a set of thrush or cheapie glass pack back there and wondered what else I need to complete the job, and perhaps any other piping pieces i may need. also, anyone know what size inlet/outlet to order. i can measure it once it's off, but i'd rather get the parts first and then r/r the muffler.
3. anyone running a cb radio antenna where the stock Mil antennas go....i'd like to see some pics and what kind of roadblock i may encounter. also, can you use the stock mil whips for a new cb radio??? not sure how all that works. thanks guys
1. I would like to make the rear power bar that is behind the pass seat on the wall 12 volt so i can run a few electronic devices from it. what is the easiest way. right now, it is disconnected from the 24 volt one bolted to the firewall.
2. i just blew out the drivers muffler last night....sounds awful. i was thinking about running a set of thrush or cheapie glass pack back there and wondered what else I need to complete the job, and perhaps any other piping pieces i may need. also, anyone know what size inlet/outlet to order. i can measure it once it's off, but i'd rather get the parts first and then r/r the muffler.
3. anyone running a cb radio antenna where the stock Mil antennas go....i'd like to see some pics and what kind of roadblock i may encounter. also, can you use the stock mil whips for a new cb radio??? not sure how all that works. thanks guys