Trango
Member
- 735
- 23
- 18
- Location
- Boulder, CO
Hi everyone,
I am getting closer to a rolling chassis on my big project, and my frame height is at a somewhat disturbingly high 51".
With big lifty springs, 48" rubber, and a body lift to fit the airshift tranny, I knew it would be high going into the project, but this is REALLY high, and I'm a bit worried. This is the height at the top of the 3" spacer I am using for a body lift.
While everything is still relatively changeable, should I think about trying to, say, take apart the leafs or anything rash? Part of me thinks it will be fine, but the other part realizes that, even though I'm a pretty tall guy, the frame is still at sternum height.
Thoughts?
Best,
Bob
I am getting closer to a rolling chassis on my big project, and my frame height is at a somewhat disturbingly high 51".
With big lifty springs, 48" rubber, and a body lift to fit the airshift tranny, I knew it would be high going into the project, but this is REALLY high, and I'm a bit worried. This is the height at the top of the 3" spacer I am using for a body lift.
While everything is still relatively changeable, should I think about trying to, say, take apart the leafs or anything rash? Part of me thinks it will be fine, but the other part realizes that, even though I'm a pretty tall guy, the frame is still at sternum height.
Thoughts?
Best,
Bob