Recent content by 4WD

Thanks for all the advice and pub # guys. (y) Just finished replacing return fuel line, tank top return bung, installed hushmat under top lid, inspected fuel filter, drained water seperator and a general cleaning. Needs a cover. I will get to work on it after a short break. All in all its...

Which publication is the droop pm listed. I have several pdf's on the machine and if you could point me in the right direction would be appreciated. THanks

Ray I set it at 61 when its a 25 %. Yesterday was first time it has run after some PM work on it. Ran from 25% to 110% load. When it was at 110% it dropped to 58 - 58.5. I adjusted it back to 60. Let it run at that to remove residue in muffler. The load got that high with a 2000 watt aux...

Keep hertz at 60 regardless of load. Read differing opinions but most say its bad for to be above or below 60 more than 2 hertz. When my ac's go on and off and particularly when both are on it can drop 2-3. Set in question is performing to spec I believe as far as handling average loads. It...

Anyone have knowledge of a electromechanical device that would automatically change hertz/rpm to 60 as load changes? I remember seing a thread or post some time back on this. Someone had set up a motor control on the hertz knob such that it had hertz input and would change knob postion to keep...

Guyfang, I downloaded those manuals back when I purchased this generator. There are some question that the manuals don't answer.

Good work. Glad it paid off.

"If you remove the rear cover hiding the tank" Are you referring to the panel on the outside of the gen set or on the interior panel adjacent to the engine, ie in the engine compartment? Thanks Edit... Found a picture in another thread and it appears the exterior panel is what I need to...

I finally gettting round to replace return fuel line. Removed top exterior engine cover no real problem there. Still confused about how to get to return line going into tank. I hope that its accessible by removing exterior cover on front/outside of tank below the fuel cap. That looks pretty...

Wish there was good test results available on the major fuel (diesel) additives that's for sale.. Sometime feel like I'm wasting $$ on hype.

I'm working on the low pressure return line. The line I'm intending to use and have purchased is the Gates Safety Stripe II Nitrile rubber. Link to Oreilly part Intending to leave return rail and down lines to injectors as is. Just replacing from return rail back to tank. Haven't begun to...

OK Thanks

Thanks Mike...What is a type break in oil.. brand, class and weight. To anyone. Purchased the 1/8" fuel line from oreilly. They didn't have clamps that small in stock. Any suggestions on a part # and brand for clamps. Line measures od 0.3". Zip ties would work temp as it low p. # 4...

A switch by another name. The one that cuts off gen output. In middle bottom row control panel. Im in bed and not getting to check its other name till the pot starts brewing. Edit ...believe its called on drawing K1 AC CIRCUIT INTERRUPTER

Completed temporary return line using copper model airplane fuel line as splice and did test run. About two hours up to 75 % full load. Much quieter than my old gas 5700 watt. No flickering of some LED as in the past under gen power. Had some confusion regarding AC bypass switch. Thought it...