Recent content by AOR

I am looking for a front jack crank handle for a m101a3 trailer. Any info on where to obtain would would be appreciated.

Thank you for all the info. This one has a flat bed on it. It is an interesting looking unit. If it sells for cheap enough I may bid on it.

Here is a pic from the auction listing

It’s at a local auction they do have the data plate. I was not able to get anything on google. Here is the picture

Can anyone identify what model of trailer this is and what it was used for? Thank you.

If the ID tag with ratio is not bolted to the diff with a cover bolt you can remove the cover the ring gear should have numbers stamped in it which will tell you the amount of teeth on the ring and the pinion gear. If not count the teeth of each gear and divide the amount of pinion gear teeth...

we ordered multiple choices from Napa and the one that matched based on specs the sleeve pocket was to loose to be acceptable. Please share the part number if you still have it

It’s for the front at the rear of the front spring that go in the frame the ones we removed are whopped

Can someone please help me find front upper shackle bushings that go into the frame for an m1009 Blazer 1984 model. We have ordered several and they have all been wrong. This one uses 7/16 bolts. We have been ordering for the civilian K5 Blazer. Is there another civilian application that may...

most of the time there will be numbers stamped into the ring rear which is easy to see with the cover off when rotated in the correct viewing area its an AMC 20 mine had them just unbolt the cover no need to remove the diff itself rotate it look for numbers example 41 10 you divide the small...

I still have a good diff I think its the 2.56 or whatever was numerally lower I can sell to you if you have the same ratio I see you have a 703 number so you are not far from me I sold the vehicle the issue I had was hard to explain I felt the driveline binding and it whined more than expected...

I recently acquired an M105A3 trailer that I assume sat for many years. I towed it for about 50 miles and it made it home but when I got home the brakes smelled really hot and bad. When I went to move it again the wheel drags and locks up in my gravel lot. I am in the process of trying to remove...

It was nice meeting you as well thank you for the information I will pm him I think bunji cords may work good enough I was parking the trailer yesterday it rolled fine all the way here and now the left brake is locking up without touching the brake pedal only when moving forward I think...

I picked up a M105A3 this past weekend that has the M105A2-A1 cover on it. The ropes on the cover do not line up with the tie downs welded to the cargo body. I found some pictures of the correct cover and I was told that the correct A3 cover uses rubber type cords to tie the cover down. The...

I haul all my stuff on a 14k 102” wide deck over trailer no fenders to worry about. The HMMWV is fairly light load at 5200 lbs but with the engine and drivetrain mounted to the passenger side and on an angle and with most of the weight upfront I use my air bags on my ram 2500. I have hauled...