Recent content by captw

are two or three batteries being using in this application?...I assume that three are being used, one charged by the 12v alternator separately and two others connected in series being charged by the 24v alternator. Correct??

WC identification Gilles...see what engine is in it...judging by the hood panel cut out on the lower right rear corner, it may be a conversion that someone did to a CDN APT, the same type truck I was driving in the Coe Hill parade, Shore Patrol...Wilf

Dana 60 kingpin parts Hi guys/gals...I see throughout most of this thread that people are using bushing/spring kits from ORD....I found a website, AllJeep.com, which lists the individual Dana parts, and total price is cheaper than ORD kit, shipping is cheaper also...I spoke to them on the...

seat latch under normal conditions the seat back will always be free to move, there is no latch to lock it in place...the catch and pawl mechanism in the pic only comes into play, or at least is supposed to, in a collision situation...there is no spring, it works as a pendulum, and swings into...

safety latch when properly assembled, this latch is supposed to engage the pawl on the seat back to prevent the seat back from moving forward in the event of a frontal vehicle collision...W

fitment of vinyl covers the evil Dr. porkchop is right on the money...I have the camo cover on my M101A2 trailer which sits just above the tie downs(p/n is correct as per manual)...the bows are the proper length, not cut down as some would suggest was done when carrying a generator...my buddy...

Do over okay...not sure if you're chain yankin' or not...DO not OVERfill....in regards to radiator level, or engine oil, etc.

M1010 12v conversion and battery drain hey 41cl8m5...thanks for that info...interesting....I'll forward the info on to my buddy...I know that on my M1008, the swiches stays in the service position and no problem...W

M1010 A/C on 12V Hi Gilles...you need to send a PM to C15TA on this site...Barry's M1010 was also converted by a police agency to 12v, his battery also drains if he leaves it connected, but I'm pretty sure his A/C does work and blows cold...W

Hi guys...I'm interested to know how you access the clutch or hi/low controls on the winch, when they're mounted up behind the bumper...FYI, I have two HMMWV Warn winches and a MileMarker 10,500lb. winch...Wilf

that's Nick Denardo's TOW missile mule in the photo from Aberdeen, MD, and those tires are what was placed on the mule, in addition to the wide fenders, to operate in ares where high flotation was required...I have the same set up on my mule...W

Hi could someone please tell me how the bows are stowed on this trailer using the short stakes for that purpose?...thanx...Wilf

M/C cap just an FYI...in order for the brakes to operate properly, the cap must be vented...I have seen bothe styles of caps used on the M1**A2 series trailers w/surge brakes...mine has the muhroom shaped cap with vent hole, others have a vent line...water tends to get in the vent hole on mine...

M101CDN2 trailer first of all, that is NOT!!!!!! a 416 trailer!...the CDN trailer is a helluva lot better!...heavier trailer, similar size bed, better built...bulbs are probably still 24V, as used for the Iltis...most of these trailers never even made into CDN service, and sold surplus w/o ever...

mule accessories Ed...did I mention that in addition to BIG tires, I also have pads, seat and electric start!!...W