Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
Good info, thank you.
If you want to keep running them, AC Delco 15G or Wellman DRX00115 is what you're looking for. They're not self-regulating, though, and they tend to swell.
If you want me to muddy the waters a little more, here's a HMMWV troubleshooting manual from the AM General training department saying the HMMWV glowplugs are 12v. (Emphasis is mine)
There have been a lot of arguments over that question, but the consensus around here is no, they're not the same. There are data sheets from the manufacturer floating around that say they're both designed to operate at ~12v and they're just marked "24v" for the application, but I haven't dug...
The glow plugs in the 1028 sound like 15G HMMWV glow plugs. The ones on the 1008 are probably AC Delco 13G or 60G.
The 60Gs are arguably the best glow plugs as they don't tend to swell as much. You can easily clip the ends of the wires and install whatever connectors you desire.
Once or twice a year, I'll take a can of CRC marine corrosion inhibitor and blast it into the drain holes on the inside of the fender wells. I know correlation doesn't imply causation but it couldn't hurt and I don't have any rusted out fender wells yet!
If everything is operating properly, leaving the service light switch on isn't going to cause it to go dead in two weeks. My batteries are pretty weak and my Gen 2 has bad diodes and I can leave my truck parked for months with the service light switch on and not have an issue. In fact, I never...
Mine does the same thing with the Gen 2 light staying on and low voltage until I blip the throttle. The generator has been needing replaced for a solid 6 months, as evidenced by the very slight glow of the Gen 2 light all the time. It still charges, though, so I haven't got around to replacing...
If I recall correctly, the light should turn on with the wire pulled off of the sensor and then turn off when the wire is grounded. If it does, the sensor is bad. If it doesn't, either the low coolant module under the dash is bad or you have a bad wire/corroded connection.
You might want to...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!