Recent content by Flowmastr

So, new 1N5406 3 amp diode. Fired right up dragged it outside ran it a bit. Shut it down, no 24 volts. Well wiggled the connect p8-J6 connector' Yup, 1 corroded pin set. cleaned up all good, thank you Kloppk. One more question, upon start up the under current light will come on, I dont think...

Is this common or how it behaves when bad?

E-stop out- 24volts both sides Master off- 24volts Pin 3 CB1- 24 volts both sides CR1- 24 volts both sides Estop out Master switch prime/run CR1- 178C 24volts, 162A .0132 volts Everything else previously with 24 volts- .0132 volts Estop out master off, panel light has 24 volts in the off...

24 volts all the way thru to CR1 from S10. As soon as the e stop is pulled out, I lose 24 volts on the left side of CR1

Batteries charged Dead crank-Yes S17- pulled out 24.5 volts both sides S1- off 24.5 volts pin 3 CB1- 24.5 volts both sides CR1- 24.5 volts both sides S1- master switch- any position but off, No 24 volts on any of the previous listed places As previously stated it would crank and run with a...

This one ? TM 9-2815-255-24P

Yes it dead cranks. will look into the rest today, thank you

Hello everyone, I have been searching for answers but not getting far. A friend has a 1993 MEP-805A with 21 hours on it. To begin with was it would sometimes/run start but when it it would not crank he showed me how he drops the control panel down and wiggles the wires in the area of S1 and S17...