Recent content by kendelrio

And away we go!!!!

Congrats @Soupermike!

100% this. I just did this and i had to jack the motor around, reorient the winch, order a new plate and hoses and slide some chafing gear between the motor and my radiator hose. You will also need different frame extenaions. My $500 winch cost me an additional $2500... If you are going to do...

My M715 is a tale as old as time.... Boy sees truck in a movie at an early age, boy falls in love with truck, boy see truck in another movie and 30 years later see the truck at a friends place, chews on buying said truck for 2 years, then pulls the trigger and picks it up on a Christmas eve...

They are plumbed correctly. I tested it by unspooling it completely and dragging my Ram 1500 to tighten it. Thank you.

Thank you. My brain was absolutely FRIED plumbing that.

Today was matching the new roof to the rest of the interior. Coat one is on, when its good and dry, coat two will go on. I used this paint and code from Home Depot

I know where that is!!!

I'll prime the pump..... My 1967 M715 "Dirty Gerty"

The third plug goes to the circuit breaker. PM me your address and I'll get the manual in the mail to you. It'll help you do everything you need. If you end up needing hoses, let me know.

I covered the instal on the last page of my build thread of my M1114

Is the winch off of a 998 or one of the larger REV trucks? It makes a difference. I just fought this with my front winch. You'll need three wires actually. One power to the connector to activate the directional solenoids. The plumbing is pretty straight forward. I have a physical copy of the...

Ok, as I've stated in other threads, the front winch was next. (Preface... it's CRAZY what you learn AFTER you need to know it. Until this point in my life, I thought all HMMWVs were the same frame etc, just different armor/configurations). I had bought a 10.5k Mile Marker fron winch that...

LEEETTTSSSS GOOOOO!!!!

Congrats @Joe Bertram !!!