Recent content by kubotaman

Keeping the 40k lbs rear axles? Good call on switching the front axle, does that model require dual steering boxes?

Tried the M819 manual? I believe it is the same body as the M246

If you have any decent junkyards left near you, or are lucky with Facebook Marketplace you might be able to find a good deal on a Tilt Column which will also have momentary wipers.

Going to buy a Gilette, thanks guys.

Has anyone come up with a standalone outlet panel/ power distribution panel with 120V/240V outlets and respective circuit breakers to wire directly to the output lugs on the MEP generators? We use our MEP-831A on camping trips and I was thinking about setting one up to make the unit more...

This has been a long debated topic, but I was always taught not to float synchronized transmissions which has been reinforced by every transmission rebuilder I've talked to. Sure you might save some clutch wear, but at the cost of premature syncro wear. Clutches are cheaper than transmissions...

So how did you do it?

:jumpin:

Welcome. They are fun machines. The forum for those is Motorcycle's and ATV's

If you are just trying to see what the RPM is for testing purposes, you can use a regular M-series Tach like on your M818 or M35A2. The tach drive and cable should match up

Ditto. 2 Group 31s or the batteries from your deuce will be plenty in warm weather.

Nice looking M915A1, still have the original M915A1 as well?

AMD is the best in my experience. Used them on my M1009 and was quite happy.

Nice lineup, but where is the M125A1? :jumpin:

Very good progress nonetheless. Looks great