Recent content by m35kimber

Well I got it off the t-case..... Anyone know where I could buy the kit to replace the seals and piston? I thought I could just match up a o-ring but I didn't realize it uses a special seal.

I just got around to looking at this today, is it possible to remove the cylinder assy without lowering the t-case? it looks like there's only 3/4'' clearance between the cylinder and the cross member that runs directly under the drive shaft connecting the trans and t-case.

Okay, thanks.

Hey everyone, I'm going over my deuce I recently purchased and would like to do a PM service on the front mount winch. Does anyone know exactly what's involved in this? Or what type of fluid it would use? Thanks.

Ok, thanks again for all the info.

Ok, I'll be ordering the GL-1 for the trans and t-case. What would you recommend for the axles then? 75w90? 140? Also any ideas on what oil/fluid the front winch would use?

So my best/safest option is going with napa GL-1 80-90. This will be acceptable for use in the trans, t-case and all differentials as well?

Hey everyone, just getting ready to change all the fluids in my M35A2. I've been told the gear oil needs to be a 80/90 that's compatible with yellow metal. So far i'm having some trouble finding such a gear oil. I plan on changing the fluids in the transmission, T-case and all 3 axles. Any info...

Ok thanks, i was going to give ken at kublos a call tomorrow. If the seal is the issue would it be possible to just clean it up and replace the seal?

hey everyone, just picked up my 71' M35A2 from Kublos Surplus yesterday. The truck ran great the whole ride home (4 hours) and everything seems to be working good....... however today i decided to try out the 6 wheel drive. When i flip the engagement switch on the dash i could hear a bad air...