-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
muthkw25's latest activity
-
Alright men- I have the rears on her! She looks good! The tire Tech did break one stud off, got the parts on order for this. Wes was... -
muthkw25 replied to the thread My m925a1 build "Brutus".Spoke with Warren at premco about running a Fass. My buddy runs one on his m925a1 and I was considering it. Warren stated he would...
-
muthkw25 replied to the thread My m925a1 build "Brutus".Decided to paint exhaust stack. Scuffed with sandpaper and cleaned with xylene. Used high temp primer. I tried to tape off as much...
-
-
muthkw25 replied to the thread An easier way to turbo an M800 truck.Have you thought of drilling and taping #6 cylinder to get the most accurate temps? That's what I did on my setup.
-
muthkw25 replied to the thread My m925a1 build "Brutus".Got the shock today. Talk about a waste. We wonder why cost is up in America. This giant cardboard box for the smallest shock. Also...
-
-
muthkw25 replied to the thread My m925a1 build "Brutus".The seat shock finally bit the dust on the videos posted above. Ordered a new monroe 66104. It's used in atvs. Gas shock. It's 1 inch...
-
muthkw25 replied to the thread My m925a1 build "Brutus".No leaks! After truck is warm oil pressure drops 35psi at idle. Under throttle it's about 70psi warm. Much more accurate than the old...
-
-
muthkw25 replied to the thread My m925a1 build "Brutus".Didnt get any photos of the an line behind the dash but I got it to fit. I got a photo of the an line attached to the block. I removed...
-
-
muthkw25 replied to the thread My m925a1 build "Brutus".Thought I was out of the woods but putting the gauge cluster back in caused a leak near the fitting at the gauge. Not much room behind...
-
muthkw25 replied to the thread My m925a1 build "Brutus".Got the gauge installed. Put a T fitting at the block so I can run a fass down the road. Used a 24v led green bulb like other gauges...
-
-
muthkw25 replied to the thread My m925a1 build "Brutus".Got the old oil pressure gauge out. That was not easy. Got the new copper line run and the fitting to the gauge. Tomorrow I'll test...
-
-
muthkw25 replied to the thread My m925a1 build "Brutus".Thanks Superthermal, permanent rapid weightloss. Haha
-
Very unusual for one of these trucks to ever go on a diet and to loose weight and 1000 lbs at that! Man that is impressive! ;)
-
muthkw25 replied to the thread My m925a1 build "Brutus".Got the spare tire up in position. So much more room for activities! I kept the spacers I used for the 16r20s in place. Fits well...
-
-
muthkw25 reacted to HoveringHMMWV's post in the thread MV of the month March 2025 nomination with
Like.
What the heck, I’ll try again. Knew I shouldn’t have grabbed that glass of wine before taking a seat on the porch.
