Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
One of my Trucklites outputs so low on high, defective. It's been that way for years. So I bought adapters and some LED lights of Amazon that have a similar appearance. The military may have the money for Trucklites and maybe I would if I thought they were worth it. There just freakin...
Duallys on my mining road did not like rocks. But I have to be careful of sidewall damage on the 14.20's because the road is narrow and full of rocks. Had a rear go and what a pain in the ass changing that sucker. On pavement is 8 tons of water to much (8 x 275 gal cubes with the last 2 half on...
Everythings cheap till you break it for sure. I have a full machineshop so hopefully if I need a tool I can make it. Being a FFL/SOT I work on 6k-60k HK's and assorted firearms daily. Some are pretty rare and parts are not around so you have to machine them. The projects themselves are...
Wess sugested it was a stuck piston in the pump. I diconected the return line before the pressure reg to verify it wasn't a plugged return line. Time to try my hand at rebuilding a P pump.
NHC 250 PT pump goes to full throttle. I had just reinstalled the PT pump on my M934A1 (NHC250). Finally chased down the lines I needed. Went to start and it went into full throttle right to grenade mode! Had to jump out and kill it with the shut off lever. I got it to idle by backing down the...
Need some help on the fitting. This is on top of the shut off valve on the NHC250 pump. What kind of male fitting goes into this (the fitting on top of the shut off valve)? A JIC #2403-05-05 seems to fit but not sure if the JIC inverted flare will seal in it. Kenny asked this question when this...
Hey Kenny
Emailed and did the contact on your site. Looking for a dual line kit. If you don't make them anymore let me know and I'll source out the fittings.
I bought new the same regulator but when I pulled my old one off it had 3 spades not 4 like the picture. The 3 spades where the 2 by the adjustment and one by the load resistor. The extra one on my new cover is right below the 2 that are in line from the adjuster. I hooked up my 3 wires like...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!