• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Recent content by Patgonia53

  1. Patgonia53

    Looking for TM for operation of M936A2 wrecker need infer on rear winch and boom op

    Just picked up a 936A2 wrecker but don't have TM for rear winch and boom operation... I looked thru the TM section, but did not see any info on wreckers. Anyone have any info or potential sources for operations info ??
  2. Patgonia53

    12 v equivalents for Deuce bulbs

    Thanks guys... thats great !!!!
  3. Patgonia53

    12 v equivalents for Deuce bulbs

    I have a duece and 101a3 + 105 trailers. I want to pull the 101 with my Dodge Ram pickup. Does anyone have a Bulb chart for changing the 24 voly signal / stop lights and marker lights to 12 volt bulbs Thanks for the help
  4. Patgonia53

    master cylinder vent / reservior

    my M35a2 has a master cylinder with vent line going to the axle tubes... can I discinnect this and attach the vent line 90 degree connector to a brake fluid reservior in the engine compartment?? Do you REALLY need the vent line.... Some master cylinders come without a hookup for vent lines...
  5. Patgonia53

    M923 transfer case solenoid

    Anyone know of a replacement part for the transfer case solenoid on a 923 A2.. alternitive part number of sourse for new or rebuilts would be greatly appreciated
  6. Patgonia53

    Digger09 Great guy.. thanks

    I posted a "Parts Wanted" ad for a set of 5 ton bows and hardware.. Got a couple of good replies and some helpful suggestions from guys on the board.. I got an offer for the complete parts set from Digger09 in NJ. after a few pm's.. we spoke on the phone (very nice guy to converse with)...
  7. Patgonia53

    keyed battery switch for 923

    I am installing a keyed battery switch for my 923... 4 wire go into the switch.. but I cant tell how to divide them ... to a 2 poled caterpillar switch.. looks like wire # 569 comes in from the battery to the battery switch... 81 and 81A go back to starter and 459 goes to the electrical...
  8. Patgonia53

    5 ton bedliner

    I actually need something with a little more traction... My SWAT team is going to use this for team deployment during callouts... when we roll with a big team
  9. Patgonia53

    5 ton bedliner

    Diverman What company did you use for your 2500.. LineX ???
  10. Patgonia53

    5 ton bedliner

    i was thinking more on the lines of a "bedliner" like in a pickup... something better and more durable than paint... not quite the level of reinforcing steel But thanks for the information
  11. Patgonia53

    5 ton bedliner

    Anyone ever put a bedliner in a 5 ton.. rather than just paint..??? Do it your self or commercial Any experience with lineX... I have it in my pickup, and it seems to have held up well... but this is a different story
  12. Patgonia53

    Air control for trailers

    ok... thanks guys... I will hook it up and check it out
  13. Patgonia53

    Custom Bob, 50 Cal, Flames out dual stacks , hummer front end, custom bumpers

    GREAT TRUCK !!!!!! GREAT CAUSE !!!! What spray on bedliner did you use on the sides and battery / storage box's
  14. Patgonia53

    Air control for trailers

    I dont even know where to begin to look for this... is there a switch or button that releases or holds air in the system and transfers it to m105 trailer... except attaching the glanhands... Just got my M105 and my diesel mechanic friend said "all trucks have a botton or switch that sends...
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks